Häfele Red Jig Mode D'emploi page 30

Bedinungsanl_UnitoolMulti_neu
3. Drilling horizontal holes (central face drillings) for wood thicknesses of 15,16,18,19 and
22 mm.
There are two vertical drill guides available, one for wood thicknesses of 15 mm and 18 mm and
one for wood thicknesses of 16 mm, 19 mm und 22 mm. Exchanging the drilling sleeves allows
you to either drill ø 5 mm, ø 8 mm or ø 10 mm holes. The drill guides can be adjusted or
exchanged by unscrewing both knurled screws. Push the knurled screw into the hole that
corresponds to the wood thickness. The drill holes on the jig body and on the drill guide are
positioned in such way that the vertical drill guides can only be attached to threaded drill holes
that suit the corresponding wood thickness (fig. 9 shows 19 mm for example). Secure the jig by
tightening the clamping screw that is attached to the jig body. Now drill the hole with the
appropriately adjusted stop ring (suitable stop rings can be found on the catalogue page "Unitool
Multi").
4. Drillings for TAB or TAB V connectors
For this work step you need the following tools that are not included in this packing unit:
4.1. Slide the drill guide into the jig body (fig.10).
4.2. Secure the drill guide by screwing one of the vertical drill guides onto the jig body (fig.11).
4.3. Slide the jig onto the work piece as far as the edge of the work piece (fig.12).
4.4. Secure the jig by tightening the clamping screw that is attached to the jig body.
4.5. Now drill the hole with the appropriately adjusted stop ring (fig.12).
Fig.10
2005-09-26 530 rL
23.05.2006 15:03 Uhr
Fig.9
Tab V drill guide (Cat. No. 001.25.025)
HW multi-spur drill bit* ø 18 mm (Cat. No. 001.06.618)
Stop ring for multi-spur drill bit* ø 18 mm (Cat. No. 001.42.693)
Fig.11
- 3 -
- 10 -
Seite 10
Fig.12