Fault Messages And Fault Elimination; Accessories; Disposal; Warranty - Weller Zero-Smog Manuel D'utilisation

8-8
Fault
No extraction capability
WFE 2ES does not start up
HEPA filter contaminated too
quickly

8 Fault messages and fault elimination

Possible cause
− Pipe system leaking
− Filter contaminated
− Thermal cut-off
− No pre-filter inserted

9 Accessories

T005 36 571 99 KIT1WF for WFE 2 surface extraction
T005 36 572 99 KIT1WF for WFE 2 surface extraction
T005 87 358 62 Filter housing
T005 87 627 53 WFE adaptor 50-60 mm
T005 87 627 56 Extraction hose, Ø. 60 (5 m)
T005 87 627 01 E12 filter set with 10 M5 prefilters
comprising: E12 EPA filter, wide band gas filter
(10 % activated charcoal)
T005 87 627 03 Fine dust filter M5 (10 pieces)
T005 87 627 04 Housing upper section
Fine dust filter for Compact filter:
T005 87 359 36 E12 EPA compact filter +gas filter
T005 87 359 37 Fine dust filter M5 (10 pieces)
T005 87 359 38 Fine dust filter F7 (10 pieces)

10 Disposal

Dispose of replaced equipment parts, filters or old devices in
accordance with the rules and regulations applicable in your country.

11 Warranty

Claims based on defects will fall under the statute of limitations
12 months after delivery to the purchaser of the goods. This shall not
apply to rights of recourse of the purchaser according to sections
478, 479 German Civil Code.
We shall only be liable in the case of a warranty we have issued if
the quality or service life guarantee has been issued by us in writing
with reference to the term "warranty".
Subject to technical alterations and amendments! See the updated
operating instructions at www.weller-tools.com.
Corrective measures
− Seal pipe system
− Change filter
− Allow the WFE 2ES to cool
down
− Switch on again after approx. 3h
− Insert pre-filter
− F7 Insert pre-filter
− Insert pre-separator (with high
solids content)
WFE 2ES