Safety Considerations; Dimensions And Arrangements - Dustcontrol TPR 50 Manuel D'instructions

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 37

Safety Considerations

Read all instructions before attemting to operate this
machine.
The equipment must be installed and maintained pro-
perly by qualifi ed personnel who have study this user
instruction. Dustcontrol does not take responsibility
for defective installation or maintenance.
Warning! When using electric machines, basic safety
precautions should always be followed to reduce the
risk of fi re, electric shock and personal injury, inclu-
ding the following:
Work area environment
1.
Keep the area around the central unit clean. Do
not store or work with fl ammable liquids or gases
near the machine.
2.
Overload
If there is an alarm signal it should be carefully
checked out to see that the machine is un damaged.
If there are any damaged parts these should be
repaired by a Dustcontrol authorized service
centre. Always follow the regulations pertinent to
the material you are working with. Do not use the
machine for purposes that it is not intended for.
3.
Bodily injuries Warning - High negative pres-
sure
Do not start the pump without having it connec-
ted to the duct work. Do not adjust the vacuum
relief valve while the pump is operating. Never

Dimensions and Arrangements

4.
5.
6.
7.
TPR 35, TPR 40, TPR 43, TPR 47, TPR 50
TPR 50, 30 kW - 13
let the suction come in contact with parts of the
body, for example a hand. The pump generates a
high negative pressure, severe injury may result.
Warning - Very hot exhaust air
Exhaust air can be very hot, up to 150
Electricity
A separate lockable disconnect must be installed
where it is readily accessible to the pump. Do
not repair the electric components yourself, get
somebody qualifi ed. Faults may cause injury. The
electrical connections may only be performed by
a certifi ed electrician. See also under section 7,
'Warning' .
Important measure
The electrical disconnect should be locked in the
"off " position before demounting the safety panels
or ducting.
Checking for damage
Check the machine regularly for damage. If there
are any damaged parts these should be repaired
by a Dustcontrol authorized service centre.
Warning
Use only accessories and replaceable parts which
are available in Dustcontrol catalogue. When
using non-genuine parts, especially filters and
plastic sacks, dust leaks could occur which may
be hazardous to health.
O
C.
Part No 9050

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

9050

Table des Matières