Reinstall Grease Filters - Broan BW5830SS Manuel D'installation, D'entretien Et D'utilisation

11. INSTALL THE DECORATIVE FLUE (
D :
UCTED INSTALLATION
Attach the 6" round duct section to the rest of the ducting. Use metal foil duct tape to seal the joint.
N - :
ON DUCTED INSTALLATION
Pull the upper flue up and attach the non-duct plenum with collar to the upper flue using 4 ST4 x 8
provided screws.
A :
LL INSTALLATIONS
Slide up the upper flue until it is aligned with its mounting bracket. The bracket must be
inside the flue. Secure the upper flue to its bracket using 2 no. 8 x 5/16" mounting screws.
NOTE: Duct (or non-duct plenum) not shown in illustration to ease understanding.
Remove protective plastic film covering the upper flue and the hood.

12. REINSTALL GREASE FILTERS

N - :
ON DUCTED INSTALLATION
Attach two non-duct recirculation filters to sides of blower by aligning key lock slot and rotating
until filters lock into place.
A :
LL INSTALLATIONS
To reinstall the grease filters, align rear filter tabs with slots in the hood.
Pull down the metal latch tab, push each filter into position and release.
Make sure filters are securely engaged after installation.
)
CONTINUED
HD1030
9
HJ0161
U
PPER FLUE MOUNTING BRACKET
F
RONT VIEW
U
PPER
FLUE
HO0287
HA0137