Toyotomi FF-V30T Manuel D'utilisation page 7

NOTE: When pressing the "sMIN." button at the position of "SAT", you
can hear the beep sound and "SAT" is not changed any more.
When pressing the "tHOUR" button at the position of "SUN", you can
hear the beep sound and "SUN" is not changed any more.
2. Press the "SET" button to complete the set of a day of the week.
The current time and the day of week will show on the display.
MANUAL OPERATION
Operation of the heater is under the direct control of the user. Heat output will, however, be automatically adjusted
in accordance with the room temperature registered by the temperature sensor.
1. Turning Heater ON
1. Press ON/OFF switch to "ON" position. The current room temperature and the set
temperature will be shown on the digital indicator. ON lamp will start to flash and then blower
motor and ignition will start. This lamp will continue to flash during the preheating time.
2. After approx. 1.5 – 4 minutes ignition will take place. (*) After ignition, ON lamp will
change flashing to continuous. Circulation fan will turn on after approx. 2 minutes.
NOTE: (*) Pre -heating depends on the room temperature.
Room temperature:
under 0˚C 4
0˚C - 15˚C 2
15˚C 1.5
2. Adjusting Room Temperature
1. Press "sMIN." or "tHOUR" button. ˚F or ˚C will start to flash.
2. Press "sMIN." or "tHOUR" button as required. Room temperature can be set from
10˚C (50˚F) to 32C (90˚F). (Initial setting : 13˚C (56˚F))
Desired temperature setting will be displayed on the digital indicator when you set the
room temperature.
When room temperature reaches the selected setting, heater will automatically shift to
"MED" or "LOW" burning mode to maintain the desired temperature.
When room temperature exceeds the selected setting by approx. 2˚C (4˚F), the heater
will automatically shut off. As room temperature drops, the heater will automatically re-
start to maintain the desired temperature.
POWER SAVER OPERATION
The Power Saver mode reduces the frequency of ignition actions, to save electric
consumption.
1. Press the POWER SAVER (DAY SELECT) button "ON" while in operation to start the op-
eration of the "POWER SAVER". "POWER SAVER" sign will be shown on the digital in-
dicator. When the room temperature exceeds the selected setting by approximately 6˚C
(10˚F), the heater will automatically shut off. As the room temperature becomes lower
than the selected setting, the heater will automatically re-start to maintain the desired
temperature.
FUEL INDICATOR LIGHT (FF-V30T)
When the information display lights up, fu 10 , it means that there is only fuel left for 10 more minutes. The count
down of the remaining heating time can be seen in the information display. You remove the fuel tank and refill
it outside the living room. If you don't refill it,you will hear an alarm signal every two minutes, warning you to
refill the removable tank. After 10 minutes the information display, fu el , blinks and the heater will switch off
automatically.
OPERATION
minutes
minutes
minutes
ENGLISH
,
6