22 OPERATION
Time and Status Display
1
2
3
Door Lock Indicator
a
• The Door Lock indicator will light up once a
cycle has started. The indicator light will stay
on until the cycle is paused, stopped or has
finished.
Wi-Fi Connect Indicator
b
• The indicator blinks during product
registration and Wi-Fi setup and illuminates
when the appliance is connected to a home
Wi-Fi network.
Cycle Status Indicator
c
• These LEDs illuminate when a cycle is
selected to indicate which stages are
included. When a cycle is running, the LED
for the active stage blinks, and the LEDs for
the remaining stages remain steady.
• Once a stage is complete, the LED turns off.
If a cycle is paused, the active stage LED
stops blinking.
Estimated Time Remaining
d
• When a cycle is selected, the default time
for that cycle is displayed. This time will
change as modifiers or options are selected.
Once the Start/Pause button is pressed, the
washer will measure the size of the load. The
estimated time may change once the load
size has been measured. If Delay Wash is
set, the remaining delay time counts down
until the cycle begins.
NOTE
• The time shown is only an estimate. This time is
based on normal operating conditions. Several
external factors (load size, room temperature,
incoming water temperature,etc.) can affect the
actual time.
4