Network Setting - Epson TM-T88V-i Manuel De L'utilisateur

English
About Network Connection
Confirming the Network Settings
Make sure the printer is turned on, press the push button at the interface part
(shown in the following illustration) for approximately 3 seconds. When you
release the button, a status sheet on which network parameters are printed will be
ejected.
With the status sheet, you can check all the settings necessary for connecting to the
network.
Note:
If you keep pressing the button for more than 10 seconds, the network settings are
initialized. (See "Initializing the Network Setting" on page 8.)
The printer is initially set so that the IP address for the wired LAN will be obtained by
DHCP. When you turn on the printer, the IP address is obtained and then it will be
printed out automatically.

Network Setting

Make the same settings on the computer and access points as those printed in the
status sheet.
Use the web browser to make the network settings. Input the printer's IP address
in an address bar of the web browser, and make the network settings as directed
in TM-T88V-i Technical Reference Guide.
Initializing the Network Setting
To reset the network settings to the default values, press the push button at the
interface part (shown in the following illustration) for more than 10 seconds.
When you release the button, the initialization will be started.
8 TM-T88V-i User's Manual
Status LED
Orange: Booting
Green: Operating normally
Push button