Test Printing; Attaching The Power Switch Cover - Epson TM-T88V-i Manuel De L'utilisateur

Changing the Paper Width
If a roll paper guide is included with your printer, you can change the printer paper
width from 80 mm to 58 mm by installing the roll paper guide. Follow the steps
below to change the paper width.
CAUTION:
If you once change the paper width from 80 mm to 58 mm, you cannot
change it back to 80 mm.
When changing the paper width, be sure to make the setting for the paper
width with utility software for the TM-T88V.
1. Press the cover open button to open the roll paper cover. (See illustration F.)
2. Install the roll paper guide so that the projection on its bottom is aligned with
the hole at the right of the roll paper holder, as shown in illustration J.
3. Tighten the enclosed screw to fix the roll paper guide.
4. Affix the enclosed 2 strips along the roll paper guide on the bottom of the roll
paper holder, as shown in illustration K.
Make sure the space between the top edge of strips and the line of the groove
in the roll paper guide (indicated as a in the illustration) is 0.5 mm or less.
5. Install the roll paper correctly.
6. Close the roll paper cover.

Test Printing

After the printer setup or when the printer is not operating correctly, you can
check the printer operation with test printing. If the printer performs pattern
printing when you follow the steps below, the printer is operating normally.
1. Make sure the paper is correctly inserted and all the covers are closed.
2. While pressing the Feed button, turn on the printer.
3. After the printer prints its status and the Paper LED flashes, press the Feed
button again to restart the test printing.
The test printing is completed when "*** completed***" is printed.

Attaching the Power Switch Cover

The enclosed power switch cover ensures that the power switch is not pressed
accidentally. You can turn the power switch on and off by inserting a sharp-
pointed object in the holes in the power switch cover. To remove the cover, use a
sharp-pointed object.
To use this cover, install it as shown in illustration L on page iv.
WARNING:
If an accident occurs with the power switch cover attached, unplug the power
cord immediately. Continued use may cause fire or shock.
TM-T88V-i User's Manual 7
English