Factory Default Reset; Emergency Key Override - Allegion Schlage Sense Mode D'emploi

Masquer les pouces Voir aussi pour Schlage Sense:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Factory Default Reset

When should you perform a Factory Default Reset?
• If you want to move the lock to a different door, you need to restore default settings,
move the lock to the new door, and then set up the lock again.
• If you have forgotten your Programming Code, you can restore the default codes.
• If you have set up your lock using the mobile app, and would like to force the lock to
unpair from all mobile devices, erase all codes, and restore the factory default settings
and default codes.
Locate the default Programming and access codes on the front of this guide or the back
of the Alarm Assembly before beginning! Default Programming and access codes will
be restored. All existing access codes and current Programming Code will be erased.
CUSTOMER SERVICE CANNOT RETRIEVE LOST DEFAULT CODES! DO NOT RESTORE
FACTORY SETTINGS UNLESS YOU CAN LOCATE THE DEFAULT CODES. See Setup
Code and Default Access Codes on page 4.
Using the app, delete the lock. The app will attempt to return the
lock to factory default settings. If successful, the touchscreen will
flash the green check mark. Continue to step 5 below.
1. Disconnect the batteries. See Replacing
the Batteries on page 6.
2. Press and hold the Outside Schlage Button.
3. While holding the Outside Schlage Button,
reconnect the batteries.
4. Release the Outside Schlage Button.
L If you are moving the lock to a new
door, install the lock on that door before
continuing.
5. To check that the lock was reset, press
the Outside Schlage Button and enter
one of the default access codes. See
Programming Code and Default Access
Codes on page 4.
6. If the reset was successful, the lock will
perform a setup routine. Wait until the bolt
stops moving. The reset and setup are
complete.

Emergency Key Override

Emergency Key Override can be used when
the battery is completely dead, or when no
valid access code is known.
Insert key and rotate to unlock, just like any
lock. See Replacing the Batteries on page
6.
This lock may be rekeyed to match other
locks in a residence. Contact a locksmith for
assistance.
14
WARNING

Publicité

Table des Matières
loading

Table des Matières