Setting The Start Address; Additional Functions; Rotating The Display - Stage Line electronic WASH-40LED/SW Mode D'emploi

1) Press the button MODE / ESC repeatedly until
the display indicates
2) Use the button or
: 8 DMX control channels
: 13 DMX control channels
3) Press the button ENTER.

8.3 Setting the start address

For separate control of all DMX units connected to
the light controller, each unit must have its own
start address. If the first DMX channel of the spot-
light is to be controlled by the light controller via
DMX address 5, for example, set the start address
on the WASH-40LED to 5. All other DMX channels
of the spotlight will be automatically assigned to the
following addresses.
Example (for 13 control channels):
For start address 5 for channel 1, the channels 2 to 13
are assigned to the addresses 6 to 17; the address 18 is
the next possible start address available for the following
DMX-controlled unit.
1) Press the button MODE / ESC repeatedly until
the display indicates
start address).
2) Press the button ENTER.
3) While the first character on the display flashes,
use the buttons
desired ( to
4) Press the button ENTER.
After the start address has been set, the spotlight
can be operated via the DMX controller. A dot on
the right-hand side of the display flashes to indicate
that control signals are being received.
Note: Even if the address desired is already indicated in
step 1), press the button ENTER twice to have the spot-
light controlled via DMX.
9

Additional Functions

9.1 Inverting the pan direction
To match the pan direction of the spotlight to, for
example, other jointly controlled spotlights:
1) Press the button MODE / ESC repeatedly until
the display indicates
2) Use the button or
tion is to be inverted (
3) Press the button ENTER.
.
or
to select:
(xxx = current DMX
or to set the start address
).
.
or
to define if the pan direc-
) or not ( ).
9.2 Inverting the tilt direction
To match the tilt direction of the spotlight to, for
example, other jointly controlled spotlights:
1) Press the button MODE / ESC repeatedly until
the display indicates
2) Use the button or
tion is to be inverted (
3) Press the button ENTER.
9.3 Limiting the pan angle
Depending on the mounting position and field of
application, it may be reasonable to limit the pan
angle of the spotlight:
1) Press the button MODE / ESC repeatedly until
the display indicates
2) Use the button or
: 180° max. pan angle
: 360° max. pan angle
: 540° max. pan angle
3) Press the button ENTER.
9.4 Limiting the tilt angle
Depending on the mounting position and field of
application, it may be reasonable to limit the tilt
angle of the spotlight:
1) Press the button MODE / ESC repeatedly until
the display indicates
2) Use the button or
: 90° max. tilt angle
: 180° max. tilt angle
3) Press the button ENTER.

9.5 Rotating the display

When the spotlight is suspended, the display can
be rotated by 180° to make sure that it can be read
correctly.
1) Press the button MODE / ESC repeatedly until
the display indicates
2) Use the button or
to be rotated (
3) Press the button ENTER.
.
or
to define if the tilt direc-
) or not ( ).
, or
to select:
.
or
to select:
(or
or
to define if the display is
) or not ( ).
GB
.
).
13