Breville Hemisphere Control Instructions page 11

NOTE
The Breville Hemisphere™ Control Blender
features a Breville Assist™ Lid. This allows the
lid to fit tightly onto the blender jug, avoiding
displacement during operation. The ring pull
design allows the user to easily remove the lid
with a simple leverage action.
Step 4
Plug power cord into a 110/120V power outlet
and turn on.
Step 5
Press the ON | OFF button on the far left of
the control panel to turn the blender on.
The ON | OFF button will illuminate and flash.
The LCD timer screen will illuminate with
'00' displayed.
NOTE
• Flashing light indicates ready to operate.
Avoid any contact with moveable parts while
in operation.
• Do not fill the blender jug above the 'MAX'
line. When the blender jug is filled at or near
the 'MAX' line place one hand on the blender
lid to avoid displacement of the lid during
operation.
Step 6
Select the required speed (1 to 5) by pressing
the corresponding speed button. The blender
will start to operate and the selected speed
button will illuminate. The ON | OFF button
will illuminate and cease to flash.
The CANCEL button will illuminate and flash.
The LCD timer screen will start counting up
in one second increments until 60 seconds is
reached.
NOTE
Operate the blender only for the appropriate
amount of time required – do not over blend.
Step 7
When 60 seconds is reached, the blender
will automatically stop blending and the
selected speed button and CANCEL button
illumination will go out. The ON | OFF button
will illuminate and flash. After a few seconds
the LCD timer screen will revert to '00'.
NOTE
• The Breville Hemisphere™ Control Blender
will automatically stop blending after
60 seconds. This is a safety feature and
restricts wear on the motor.
• To stop blending at any time, press the
CANCEL button or the selected speed
button. The ON | OFF button can also be
pressed, but this will also turn the appliance
off and all illuminations will go out.
• The speed can be changed at any time during
the blending process. Each time a new speed
is selected its button will illuminate and the
previous speed button illumination will go
out. The number of seconds on the LCD
timer screen will continue to count upwards
to 120 seconds unless interrupted.
Step 8
The Breville Hemisphere™ Control Blender
features two additional functions, 'ICE CRUSH'
and 'SMOOTHIE'. These two pre-programmed
cycles automatically adjust the blending time
and speeds to optimise blending results.
Select the required function by pressing the
corresponding function button. The blender
will start to operate and the selected function
button will illuminate. The ON | OFF button
will illuminate and stop flashing. The CANCEL
button will illuminate and flash. The LCD timer
screen will start counting down in one second
increments until '00' is displayed.
11