Parts Identification - PRO-POINT Air Shear Mode D'emploi

8380198
OPERATION

PARTS IDENTIFICATION

54
55
Left Blade (55)
Center Blade (54)
Trigger (4)
Air inlet (5)
INITIAL TOOL SET UP/ASSEMBLY
AIR SUPPLY
WARNING! To prevent serious injury from accidental operation: Do not install a female quick coupler on the tool.
Such a coupler contains an air valve that will allow the air tool to retain pressure and operate accidentally after
the air supply is disconnected.
Note: Air flow, and therefore tool performance, can be hindered by undersized air supply components.
1. The air hose must be long enough to reach the work area with enough extra length to allow free movement
while working.
2. Make sure the tool's Trigger (4) is in the off position; refer to the "Product Features" section for description of
controls.
3. Close the in-line safety valve between the compressor and the tool.
4. Turn on the air compressor according to the manufacturer's directions and allow it to build up pressure until it
cycles off.
5. Adjust the air compressor's output regulator so that the air output is enough to properly power the tool, but the
output will not exceed the tool's maximum air pressure (120 PSI) at any time. Adjust the pressure gradually,
while checking the air output gauge to set the right pressure range.
6. Inspect the air connections for leaks. Repair any leaks found.
7. If the tool will not be used at this time, turn off and detach the air supply, safely discharge any residual air
pressure, and release the throttle and/or turn the switch to its off position to prevent accidental operation.
Note: Residual air pressure should not be present after the tool is disconnected from the air supply. However, it is a
good safety measure to attempt to discharge the tool in a safe fashion after disconnecting to ensure that the tool is
disconnected and unpowered.
8
Figure A
AIr Shear
For technical questions call: 1-800-665-8685
5
4
V 2.0