Compliance Information - Festina Hybrid Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

USA / Canada
Product : 915.03B
FCCID : 2AMGUFST91503B
IC : 20965-FST91503B
Radiofrequency radiation exposure Information
For body worn operation, this watch has been tested and meets the FCC RF exposure guidelines when
used with the Soprod accessories supplied or designated for this product. Use of other accessories may
not ensure compliance with FCC RF exposure guidelines.

Compliance information

This device complies with Part 15 of the FCC Rules and RSS-247.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts
de licence.
L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
FCC Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the interfer-
ence by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
NOTICE
Changes or modifications made to this equipment not expressly approved by Festina may void the FCC
authorization to operate this equipment.
Festina Technology
Festina Technology

Publicité

Table des Matières
loading

Table des Matières