Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation instructions
Electrical Connection
Electrical installation must be performed by an
electrician qualified in accordance with the
legislation in force.
Before connecting the Warming drawer to the
electric mains, check that the voltage and
frequency of the mains matches that which is
shown on the rating plate located in the heating
block inside.
The electric connection is made via an omnipolar
switch, which is suitable for the intensity to be
tolerated and which has a minimum gap of 3mm
between
its
contacts,
disconnection in case of emergency or when
which
will
ensure
cleaning the Warming drawer. If a plug is used for
the electric connection, then it must be accessible
after installation.
The connection should include correct earthing, in
compliance with current norms. WARNING: THE
WARMING DRAWER MUST BE EARTHED.
If the flexible supply cable fitted to the Warming
drawer ever needs to be changed, it should be
replaced by an official After Sales Service,
because it requires special tools.
The manufacturer and retailers do not accept
responsibility for any damage that may be
caused to people, animals or property if these
installation
instructions
EN
are
not
observed.
4
Publicité
Chapitres
Table des Matières
