Operation Procedures - Rössler 021115 Mode D'emploi

Key functions
MODE/SELECT:
To select the function you want. Hold the
key for 4 seconds to have all function values
reset.

Operation procedures

AUTO ON/OFF:
The monitor will be automatically shut off
if there is no signal coming in for 4 minutes.
The monitor will be auto-powered when
start exercise or press the key.
FUNCTIONS:
TIME: Auto-memorize the workout time
while exercising
SPEED: Display the current speed.
DIST: Accumulate the distances while
exercising.
CAL: Auto-memorize calories amount
consumed while exercising.
SCAN: Automatically scan through each
function between SPEED-DISTANCE-TIME-
CALORIE.
Batteries
If the display on the monitor doesn't show
what it should, please replace the two 'AA'
type batteries to have a good result.
Maintenance
Verify that all the bolts and nuts are locked
properly and the turning parts should be
turned freely without damaged parts.
Clean the equipment with soap and slightly
damp cloth only. Please do not use any sol-
vent to clean the equipment.
Malfunctions and treatment
Base is unstable. Floor is not flat or there is
small object under the front or rear stabilizer.
Remove the object. The rear stabilizer end
caps have not been leveled when assem-
bling. Adjust the rear stabilizer end caps.
Handlebar or seat cushion is shaking. Tighten
the bolts and saddle post knob.
Loud noise from the moving parts. The
interval of the parts is improperly tightened.
Open the covers to adjust.
No resistance while using the equipment.
The interval of the magnetic resistance
increases. Open the covers to adjust.
Tension control is damaged. Change the
tension control.
Running belt slips. Open the covers to adjust.
The bearing set is damaged. Change the
bearing set.