Recommended Tools For Installation; Preparing The System For Installation - Watts Big Bubba Manuel D'installation, D'utilisation Et D'entretien

Installation

Recommended Tools for Installation

• Small knife to cut box tape
• Variable speed hammer drill and
(If installing on concrete)
• Adjustable wrench
• General plumbing tools for your specific plumbing type
• Plumbing Tape
• Silicone O-ring lubricant

Preparing the System for Installation

NOTICE
The Watts Model BB-S100 is factory packaged with inner pack-
aging for added protection. This internal packaging must be
removed from the system before beginning installation.
Step 1 -
Remove the packaging bands from the system box
and open the top flaps of the box. Remove the black foam pack-
aging pad.
Step 2 -
Remove the upper cardboard packaging tray and
locate the pressure gauge, flow monitor with flow meter box
marked "BB-M100", system manual, 2" PVC plumbing adaptors
(2 each), plumbing adaptor O-ring (2 each) 2" Male Glue X 1"
FNPT PVC plumbing bushings (2 each), and anchor mounting
bolts (3 each) all packaged within the cardboard tray. Keep these
components in a safe location for later installation steps.
Step 3 -
Lift up on the system box to remove it from the filter
system. Then lift filter system out of its bottom box and set it ver-
tically on the floor.
Step 4 -
Note the two instruction tags at the top of the filter
housing instructing the installer to "Remove Foam Packaging"
located inside the filter housing. To remove filter housing lid, loos-
en all eyebolt nuts counterclockwise, allow bolts to swing and
relax downward, then lift up on filter housing lid.
8
IOM-WQ-BB-S100
⁄ " concrete drill bit
3
8
SLIGHTLY UNSCREW
EYE BOLT NUT TO
SWIVEL BOLT DOWN
2130
Step 5 -
Remove foam packaging pieces: A. from lid of filter
housing and B. from top of filter cartridge. To remove foam piece
B it may be necessary to remove filter cartridge by rotating fil-
ter cartridge ½ rotation counterclockwise, then lifting up on the
filter cartridge. Once exposed, remove foam piece B. For addi-
tional information on filter cartridge removal see Filter Cartridge
Replacement Procedure in this manual.
REMOVE FOAM
FROM TOP LID &
DISCARD
REMOVE
TAGS 2 (EA)
"REMOVE
FOAM
INSERT"
Step 6 -
Ensure filter housing lid O-ring is properly seated on
INLET PRESSURE
top of filter housing and reinstall filter housing lid. Swing the eye-
GAUGE
bolts into the upward position, and tighten nuts hand tight in an
TO FACE AT PROPER
ANGLE FOR PROPER
opposing style pattern. Continue tightening nuts in this opposing
VISUALIZATION
pattern until all are fully hand tight.
7
4
A
EDP# 68110146
REMOVE FOAM
STRIP FROM
HOUSING &
DISCARD
1
5
3
6
8
2
© 2021 Watts