Recommended Tools For Installation; Using Quick-Connect Fittings; System Diagram - Watts Pure H2O H2O-DWUF300 Manuel D'installation, D'utilisation Et D'entretien

Contents of Whole
House Filtration System
Please make sure all of the items listed below are contained in the
box. If any of the items are missing please contact retail customer
service at (888) 321-0500 prior to installing.
• Filtration System
• Sediment, Carbon, UF Membrane Filters (attached to filter head)
• Parts Bag (screws, valve, brass fittings, tubing)
• Faucet with all assembly parts
Recommended Tools
For Installation
• Small knife or tube cutter
• Variable speed drill
• 1/8" (3mm), 1/4" (6 .4 mm) and 7/16" (11 .0mm) drill bits
• 1/2" Diamond Tip Drill bit (for porcelain sinks)
• 1/2" hole punch (for stainless steel sinks)
• 1/2" and 5/8" open-end wrenches (or an adjustable wrench)
• Phillips screwdriver

Using Quick-Connect Fittings

Cutting
Cut the tube square . It is
essential that the outside
diameter be free of score
marks, and that burrs and
sharp edges be removed
before inserting into fitting .
Connecting
Make certain to push
the tubing completely
into the connector until
it comes into contact
with the internal tubing
stop . The collet (gripper) has stainless steel teeth which hold
the tube firmly in position while the O-ring provides a permanent
leak proof seal .
Pull on the tube to check that it is secure . The system must be
tested prior to leaving the site and/or before use .
Disconnecting
To disconnect, ensure the
system is depressurized
before removing the tube .
Push in collet squarely
against the face of the
fitting . With the collet held in this position, the tube can be
removed . The fitting can then be reused .

System Diagram

Parts List
Item
A
B
C
D
E
F
G
Page 3
HOT COLD
A
B
Description
Adapt-A-Valve
Green Tube -1/4"
Blue Tube -1/4"
Sediment Filter (H2O-F14)
Carbon Block Filter (H2O-F12)
Ultra filtration Membrane (H2O-F15)
Non Air-Gap Faucet - Chrome
G
C
D E F