Troubleshooting For Anynet - Samsung 6 Serie Mode D'emploi

¦

Troubleshooting for Anynet +

Problem
Anynet + does not work.
I want to start Anynet + .
I want to exit Anynet + .
The message
'Connecting to Anynet+
device...' appears on the
screen.
The Anynet + device does
not play.
The connected device is
not displayed.
The TV Programme
cannot be recorded.
The TV sound is not
output through the
receiver.
Possible Solution
● Check if the device is an Anynet + device. The Anynet + system supports Anynet + devices
only.
● Connect only one receiver (home theatre).
● Check if the Anynet + device power cord is properly connected.
● Check the Anynet + device's Video/Audio/HDMI 1.3 cable connections.
● Check whether Anynet + (HDMI-CEC) is set to On in the Anynet + setup menu.
● Check whether the TV remote control is in TV mode.
● Check whether it is Anynet + exclusive remote control.
● Anynet + doesn't work in certain situations. (Searching channels, Operating Media Play,
Plug & Play, etc.)
● When connecting or removing the HDMI 1.3 cable, please make sure to search devices
again or turn your TV off and on again.
● Check if the Anynet + Function of Anynet + device is set on.
● Check if the Anynet+ device is properly connected to the TV and check if the Anynet +
(HDMI-CEC) is set to On in the Anynet + Setup menu.
● Press the TV button on the TV remote control to switch to TV. Then press the TOOLS button
to show the Anynet + menu and select a menu you want.
●
Select View TV in the Anynet + menu.
● Press the SOURCE button on the TV remote control and select a device other than Anynet +
devices.
●
Press P >/<, PRE-CH, and FAV.CH to change the TV mode. (Note that the channel
button operates only when a tuner-embedded Anynet + device is not connected.)
●
You cannot use the remote control when you are configuring Anynet + or switching to a view
mode.
●
Use the remote control when the Anynet + setting or switching to view mode is complete.
●
You cannot use the play function when Plug & Play is in progress.
● Check whether or not the device supports Anynet + functions.
● Check whether or not the HDMI 1.3 cable is properly connected.
● Check whether Anynet + (HDMI-CEC) is set to On in the Anynet + setup menu.
●
Search Anynet + devices again.
● You can connect an Anynet + device using the HDMI 1.3 cable only. Some HDMI cables may
not support Anynet + functions.
● If it is terminated by an abnormal situation such as disconnecting the HDMI cable or power
cord or a power failure, please repeat the device scan.
● Check whether the antenna jack on the recording device is properly connected.
● Connect the optical cable between TV and the receiver.
English - 42