Beper 50.940A Manuel D'instructions page 13

Multifunctional steam brush Use instructions
Cleaning and maintenance
1.Make sure the plug has been removed from the socket and has cooled down, before you maintain
the appliance.
2.Maintenance
Clean the upper part of the appliance with a damp cloth.
Remove blockages with a tooth pick on the steam outlet.
Troubleshooting
Prolem
No steam
Water dripping
The soleplate is cold
The soleplate is too hot
Technical data
Tank capacity 130 ml
Power 800-1000W
Power supply220-240V ~ 50Hz
For any improvement reasons, Beper reserves the right to modify or improve the product
without any notice.
Possible cause(s)
The steam control dial has not
been pressed
First use, the water surface has
tensile force
Any impureness in the water
There is not enough water in the
water tank.
Start steam ironing, when the
set temperature not reached
Water over the
"MAX"
The appliance is unplugged or
the temperature control dial has
been set to MIN
The temperature control dial set
not properly
13
Solution(s)
Set the temperature control dial to
a temperature suitable for a steam
ironing, and press the steam con-
trol dial.
Spray the water
Use the pure water
Fill the water tank
Wait until the pilot light has gone
out.
Put out some the water
Plug the appliance into the socket
properly or set the temperature
control dial to the required tempe-
rature
Set the temperature control dial to
the required temperature