Beper 50.940A Manuel D'instructions page 12

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Multifunctional steam brush Use instructions
Connect power supply
1.Set the temperature control dial to "Min" position.
2.Plug the appliance to the 220V socket.
Ironing function and temperature setting Fig. 3
1.Set the temperature control dial to the required ironing temperature by turning to appropriate tem-
perature indication, if the temperature pilot light has gone out, it show the temperature which you
set is reached.
2.We are advice you start ironing from lowest temperature to the highest. It's helps you as soon as
possible finishing the ironing and also avoid to harm your garment's fabric.
3.This table is for your reference, set the temperature according recommendation in the table
Operating of the steam brush (equipped with or without brush)
1.Equip the steam brush as figure shows.
2.The end of the brush has a fixing lock, equip the steam brush in the correct way.
3.Unplug the appliance after use, wait until the appliance has cooled down, when you disassemble
the brush, to avoid burn.
Material of
garment
1
Nylon
2
Silk
3
Cotton linen
Shot of Steam (plane or vertical ironing)
1.Set the temperature control dial to the high-temperature (MAX) position, if water drops out of the
soleplate, the temperature setting is too low .
2.Put the appliance on its heel and plug it in, heating it to required ironing temperature, start ironing
when the temperature pilot light has gone out.
3.Each 3-second a cycle press the "steam control dial", it can generate shot of steam.
4.Attention: because of the soleplate to high temperature, it's possible spurt some of the white ste-
am, this is the reason of water evaporation, it's not a malfunction, you can use it as normal.
5.This function can also be used for vertical state.
Storage
Make sure the plug has been removed from the socket and the soleplate has cooled down, set the
steam control dial to position "MIN", empty the water tank and press the steam control dial to elimi-
nate residual water from the tube.
Required tempe-
rature
80-100°C
100-140°C
180-220°C
Time
Temperature range
10s
Low
30-40s
Low-middle
1,40s
Middle-High
12
Symbol

Publicité

Table des Matières
loading

Table des Matières