ClearSounds CSC1000 Mode D'emploi page 50

TROUBLESHOOTING
No dial tone
1. Check that all phone cord connections (including the
curly cord) and AC adapter are security plugged into the
telephone and wall jack.
2. Check that the phone is in the correct dialing mode: tone
or pulse (page 23).
3. Plug another phone into the wall jack to make sure your
phone service is working.
No audible ringer
1. Make sure the ringer is not turned off (pages 16-17).
2. Check the volume level of the ringer (pages 16-17).
3. Verify the AC adapter is securely plugged into the AC
outlet and telephone.
4. You may have too many extensions on your line. Try
unplugging a few a devices.
No Strobe ringer and/or bed shaker will not activate
1. Make sure the strobe and/shaker switch is turned ON
(page 17).
2. Make sure the bed shaker is plugged into the correct jack
(page 17).
3. Make sure the bed shaker is plugged in all the way.
No amplification
1. Check to see if the Amplify button is
should be lit (pages 14-15).
2. The AC adapter is required; make sure the AC adapter is
plugged into the wall and into appropriate jack on the
phone.
Low handset or speaker volume
1. Check the receiver or speaker volume settings.
50 – ENGLISH
ON. The red light