ClearSounds CSC1000 Mode D'emploi page 21

into the handset, lift the handset, listen for dial tone
and dial the number. Speak into the handset and adjust
your volume. To end the call, replace the handset to
the base.
3. If you are using the 3.5mm Audio jack and want to speak
into the speakerphone, press the Speaker key, listen for
dial tone and dial the number. Speak into speakerphone
(the conversation will be heard through both your audio
equipment and over the speakerphone) and adjust your
volume. To end the call, press the Speaker key again
on the base.
4. If you are using the 2.5mm Telephone headset jack for
total hands-free communication, leave the handset in
the cradle. Press the Headset key, listen for dial tone
and dial the number. Talk into the headset microphone
and adjust your volume. To end the call, press the
Headset key.
Dialing from Standby Mode
You can enter the desired phone number in standby mode,
which allows you to verify the number before dialing. If you
have the TALKING DIALING function turned ON, the number will
be announced as you dial (see page 24 for more information).
Follow these steps:
1. Enter a telephone number (up to 32 digits) and verify
it is correct. If you make a mistake while entering a
number, press the Clear soft key to delete it.
2. When the number appears correctly, lift the handset or
press the Speaker key and it will dial.
Dialing from the Caller ID List (see page 37)
Dialing from the Redial List (see page 28)
21 – ENGLISH