Visual Indicator; Speakerphone; Answering A Call - ClearSounds CSC1000 Mode D'emploi

█ Using your Visual Indicator
The red flashing visual indicator on the base will flash to alert
you to new calls received or if you have a voice mail message
waiting from your service provider. To turn this feature OFF,
see page 34.
█ Using your Phone with Hearing Aids and Cochlear
Implants
Your phone can be used with hearing aids and cochlear implants
equipped with a telecoil (T-coil). Adjust your hearing aid "T-
switch" to the "T" position. Make sure to hold the handset
close to your T-coil.
█ Using your Speakerphone
For optimal speakerphone performance, avoid the following:
• Areas with high background noise (The microphone might
pick up these sounds and prevent the speakerphone from
going into the receiving mode when you finish talking).
• Surfaces affected by vibration.
• Recessed areas such as in a corner, under a cupboard, or
next to a cabinet, which can generate an echo effect.

█ Answering a Call

NOTE: Make sure the ringer switch is set to HI, MED or LO, or
the phone will not ring. If you have selected the strobe to be
ON, it will flash on all settings.
Using the Handset
1. To answer a call, lift the handset and speak.
2. Adjust your volume and tone settings if needed.
3. To end the call, replace the handset on the base.
Using the Speakerphone
1. To answer a call, press the Speaker key on the base.
18 – ENGLISH