ClearSounds CSC1000 Mode D'emploi page 12

potential interference, the phone should not be located near
electronic equipment, such as personal computers, television
or microwave ovens.
Begin by removing the clear plastic Caller ID protective tab.
This film tab is only for display and to protect your Caller ID
display during shipping.
Desk / Table Mounting
1. Plug the AC power adapter into the jack on the back of
the telephone. Wait until the phone is completely setup
before plugging the AC adapter into the electrical outlet
or surge protector. NOTE: The adapter is required for the
telephone to work correctly.
2. Connect one end of the 6 ft telephone cord to the line
jack on the back of the phone and connect the other end
to a modular phone jack.
3. Connect one end of the coiled handset cord to the handset
and the other end to the phone base.
4. Lift the handset and listen for the dial tone. If you don't
hear a dial tone, re-check all the installation steps.
Wall Mounting
Desk tab
position
Diagram 6
Wall mount
tab position
Diagram 7
12 – ENGLISH
Diagram 8