Basic Telephone Functions - ClearSounds CSC1000 Mode D'emploi

6. Holding the phone slightly above the mounting screws
on the wall jack, push the phone against the mounting
screws so they are hooked into upper and lower keyhole
slots on the back of the phone. Slowly slide the phone
down until it snaps into place (see Diagram 8).
7. When mounting the phone on dry wall without a standard
telephone wall plate, install 2 self-tapping screws (not
supplied) at a distance of 167.5 mm (6½ inches) from
each other and located on a vertical line. Place the
phone onto the screw-heads and slide down to secure
(see Diagram 9 & 10).
8. Plug the AC power adapter into the electrical outlet.
CAUTION: To reduce risk of personal injury, fire, or
damage use only the adapter provided (MODEL AD-
101UA) listed in the user's guide.
9. Connect the handset using the coiled handset cord and
listen for a dial tone. If you hear a dial tone, your phone
is ready to use. If there is no dial tone, check all your
cords to make sure they are plugged in securely and re-
check installation steps.

BASIC TELEPHONE FUNCTIONS

█ Using the Amplification Function
Your ClearSounds® CSC1000 is equipped with a specialized
amplification function designed to adjust to your needs.
You may press the Amplify key to temporarily increase the
volume of the handset during a call. To return to normal, press
the key again. Volume levels will also return to normal when
the handset is replaced on the base after the call. Once the
Amplify key is pressed, an extra level of amplification and
tone enhancement is added. During a call, adjust the Volume
control and Tone control on the front panel of the phone to fit
the levels to your hearing requirements. The volume control
14 – ENGLISH