Tripp-Lite SmartOnline 8kVA Manuel Du Propriétaire page 13

Operation (continued)
Startup Self-Test
When you turn the UPS ON, it will enter Diagnostic Mode and perform a brief self-test lasting about 15 seconds. The results of the self-test are
shown on the LCD screen in the sequence below.
*Note: If the UPS is cold started, its
BATTERY LED will be lit.
Failed Self-Test
If a problem is detected during the self-test, the LCD will display a error message. If your UPS displays any of the following messages in its LCD,
call Tripp Lite Technical Support at (773) 869-1234 for service.
201102160 93-2897.indb 13
STARTED WITH
AC INPUT
DIAGNOSTIC MODE
FREQ OUT = 50Hz

DIAGNOSTIC MODE
INPUT 000V / 00Hz

DIAGNOSTIC MODE
RECTIFIER OK

DIAGNOSTIC MODE
CHARGER OK

DIAGNOSTIC MODE
BATTERY OK

DIAGNOSTIC MODE
DC BUS OK

DIAGNOSTIC MODE
INVERTER TEST

DIAGNOSTIC MODE
INVERTER OK

LOAD LEVEL
00.00KW / 000%
BAD BATTERY!
CALL FOR SERVICE
CHARGE BATT FAIL!
CALL FOR SERVICE
AC/DC FAILURE!
CALL FOR SERVICE
INVERTER FAILURE!
CALL FOR SERVICE
OUTPUT FAILURE!
CALL FOR SERVICE
FAN FAILURE!
CALL FOR SERVICE
13
COLD
START*
DIAGNOSTIC MODE
FREQ OUT = 50Hz

DIAGNOSTIC MODE
INPUT 000V / 00Hz

DIAGNOSTIC MODE
RECTIFIER OK

DIAGNOSTIC MODE
BATTERY OK

DIAGNOSTIC MODE
DC BUS OK

DIAGNOSTIC MODE
INVERTER TEST

DIAGNOSTIC MODE
INVERTER OK

LOAD LEVEL
00.00V / 000%
3/30/2011 9:30:52 AM