Troubleshooting - Specialized SPEEDZONE ELITE Mode D'emploi

Troubleshooting

• Display is blank or show partial digits: Change the battery or reset the computer (see page 8, 10).
• Speed/Distance is not recording: Check speed sensor/magnet alignment (see page 5).
Change battery on speed sensor and computer.
• Altitude reading is wrong: reset known altitude before each ride (see page 22).
• Computer moves on handlebar: tighten hinge bolt or tie straps. Check rubber spacer between
handlebar and mount.
Important:
• Pay attention to traffic and road conditions at all times, and always obey traffic laws.
• Your first obligation is to be attentive and ride safely.
• Never let the operation of the computer be distraction from riding safely and avoid resetting,
troubleshooting or programming the computer while riding.
• Keep the computer and all of its components tightly attached and check them regularly.
If any of the components come loose, it could become tangled in the spokes or mechanism
of the bicycle and cause an accident.
• Make sure the alignment between the magnet and the transmitter are aligned properly
and check them regularly.
• SpeedZone computers are intended for use on bicycles only and should not be used on
motorized vehicles.
• See your authorized Specialized dealer if you have trouble installing or operating the computer.
30