Setting The Alarms; Set An Alarm; Snooze An Alarm - PURE CHRONOS CD II Série Mode D'emploi

Setting the Alarms

Chronos CD has four alarms. When activated, an alarm either switches the radio on (if in
standby) and tunes to a DAB or FM radio station, activates and plays your CD (if inserted) or
sounds a beeping alarm tone.

Set an alarm

1. Press the Alarm button and repeat to select the alarm you wish to adjust (1-4).
This will start the alarm setup.
2. Using the Navigation dial, set the following options for your alarm:
On/Off
On time
Source
Last Used/
Preset
Once
Daily
Weekdays
Weekends
Finally, adjust the volume level for the alarm (represented by a bar on-screen) using the
Navigation dial and push to confirm.
That's it! You can see which alarms are currently switched on by looking at the numbered
alarm icons on the screen.
For example:

Snooze an alarm

When an alarm is sounding press the Snooze button to silence the alarm for ten minutes (the
default snooze time). The remaining time left until the alarm sounds again is shown at the
bottom of the display. Hold the Snooze button down to cancel snooze.
Toggle the alarm on or off
Set the time you want the alarm to start (hours:mins)
Choose DAB, FM, CD or tone as the sound source you want to
use for the alarm
For DAB and FM source, choose a station for the alarm to play.
'Last Used' will tune to the last station received by the radio.
'Preset' lets you select one of your saved stations
The alarm will sound at the time you have selected and not
repeat
Every day
Monday-Friday, every week
Weekends (Sat-Sun) only
Alarm 1 is
currently set
EN
9