Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
7. Cleaning
Filter cassettes (non-"R" appliances) should be cleaned with
a soft brush and, possibly, with water.
Dry the filter and container thoroughly so that dust cannot
adhere to moist parts. To prevent dirt accumulation and
encrustation, dry dust must be removed before changing
over to wet vacuum cleaning.
Clean the container and accessories with water. Wipe the
top section 1 with a moist cloth.
8. Maintenance
The filter cassettes 12 must be renewed when the suction
power declines and does not increase again after the filter
12 has been cleaned. Obviously, this presupposes that the
container 7 has been emptied and a full paper filter bag 14
has been replaced.
Shake the filter cassettes 14 once again before the filter is
exchanged. Use a coin or similar object to turn the lock 5 on
the locking bar 4 anti-clockwise by 90°, and then push the
locking bar 4 to the back. Fold open the hood and lift out the
filter cartridges 12. Insert new filter cassettes. Ensure that
the filters are correctly and securely seated. The motor
protection filter 13 must be cleaned from time to time.
Remove the filter from the motor case. Wash the filter under
flowing water and then dry thoroughly. Return the motor
protection filter. Remove any dirt. Fold down the hood and
press it lightly so that the locking bar 4 returns to its initial
position. The appliance is now properly closed.
9. Accessories
Fix the vacuum tube by inserting it in the corresponding
recesses in the rear wall of the container.
The wire basket 16 is inserted from above into the
suspension 15 in the top section 1.
10. Remedying faults
Functional faults are not necessarily always due to a
defective appliance.
Fault:
– Decreasing suction
force.
– Appliance does not
start.
No other "interventions" are permitted; please consult the
servicing workshop.
11. Technical data
Appliance
version
IS 12....
Rated
capacity
1200 W
Maximum
capacity
1400 W
Typical sound level
(acc. to
DIN EN 60704-1) 69,5 dB(A)
Connecting cable for appliances without socket:
H05VV F 2x1
Connecting cable for appliances with socket:
H05VV F 3x1.5
1 7
1 7
1 7
1 7
1 7
Possible Cause/Remedy:
Clogged filter – Clean.
Paper filter is full – Change.
Container full – Empty.
Clogges motor protection filter –
Clean.
Clogged nozzle, tube or hose –
Clean
Is the plug inserted in the socket?
Mains failure?
Is the power supply cable
broken?
Has the appliance hood been
properly closed?
Has the water sensor switched
off the appliance?
Publicité
Table des Matières
