Inserting The Battery - ACME zoopa Q cruiser 420 Mode D'emploi

.

Inserting the battery

Once the battery is fully charged, insert it into the case on the bottom of the model.
Check the polarity before you connect the battery!
Close the case. Pull down the gas stick (left) of the deactivated controller until end position. Switch on
the model and then the controller. Pull the gas stick up and down again.
After flight, you need to first switch off the model and then the controller.
The On/Off switch is located between the rear rotors.
Controller and model are already paired out of the box.
Anyway it might be possible that you need to re-bind them again. To perform this, switch on the model.
Now keep pressed the upper left button while you switch on the controller. Once the controller is
activated, move the gas stick (left) up and down again. Pairing is now successful and the model is
ready to fly.
www.ACME-online.de
All manuals and user guides at all-guides.com
ACME the game company