Dometic TEC 29 EV Instructions De Montage page 25

TEC29 EV
Install the chassis on vehicle
➤ Drill the vehicle floor on the choosed position using the cut off template 8 mm
diameter (fig. 6 5, page 5).
➤ Use the indication of the cut off template to make the openings for the exhaust
and air outlet.
➤ Fit the seal provided all around the exhaust and air outlet, between the floor of
the vehicle and the generator.
➤ Fix the chassis to the floor of the vehicle using four 8 mm nuts (fig. 6 4, page 5).
➤ Slide in the generator on the chassis and fix it with the two lateral screws
(fig. 6 3, page 5).
9.5 Securing the silencer
Observe the following instructions when installing the exhaust pipe:
• Do not create any sharp bends which will inhibit the flow of exhaust fumes.
• Align the manifold (fig. 8 1, page 6) along the housing to ensure greater damp-
ing of vibration.
• Use the exhaust pipe extension to extent the exhaust pipe (fig. 8 2, page 6)
(see chapter "Accessories" on page 20).
Secure the extension to the vehicle floor (fig. 8 3, page 6).
➤ Secure the silencer (fig. 8 4, page 6) as in one of the alternatives shown in
fig. 9, page 6 to fig. c, page 8.
9.6 Installing the tank and fuel supply line
I
NOTE
The additional tank has to be installed far from hot surfaces and has to be
installed to avoid any fuel leakage.
Please observe the following instructions for the installation location:
• The tank bottom must be positioned at a maximum of 0.3 m below the bottom of
the generator.
• The top of the tank must not be higher than the top of the generator.
➤ Lay the fuel line as straight as possible.
EN
Installation
25