Important - Hamilton Beach Commercial HWG800 Mode D'emploi

ASSEMBLY INSTRUCTIONS
w WARNING Electrical Shock Hazard. Disconnect power before
cleaning, disassembling, or assembling. Do not immerse cord, plug, or motor
in water or other liquid.
w WARNING Cut and Crush Hazard.
•
Never operate Wheatgrass Juicer unless it is fully and properly assembled.
•
Never reach into any inlet or outlet.
•
Only use the stomper to push wheatgrass into the Head.
•
Read and understand all information in this manual before use.
Slide the Screen (curved side
1.
down) into the slot on the inside
bottom of the Head until it stops.
Make sure both sides of the Screen
are within the slot (FIGURE 1).
Place the Auger Bearing onto the
2.
splined end of the Auger. Insert
the Auger into the open end of the
Head until it stops. The splines
on the end of the Auger should
protrude from the opposite end
of the Head (FIGURE 2).
Place the Rubber Gasket
3.
onto the flat surface on the
inside of the Head-Aligning
Cap below the threads.
The Rubber Gasket is
properly installed when it lays
flat on the surface (FIGURE 3).
Place the Waste Valve Washer on
4.
the Waste Valve. Then screw the
Waste Valve counterclockwise into
the tip of the Head-Aligning Cap
until it stops. Screw Head-Aligning
Cap onto Head.
Loosen the Head-Locking Screw
5.
on the Juicer Motor until it no longer
protrudes into the receptacle for the
Head Assembly (FIGURE 3).
Install the Head Assembly onto the
6.
Juicer Motor. You will need to align
the cutout on the Head with the
pin inside the receptacle
(FIGURE 4). Align the Auger
Splines with the keyways on the
drive shaft of the Juicer Motor. If the
parts do not align, rotate the Auger
end (it protrudes from the Head) a
bit and try again. Wiggling the Head
Assembly during installation may
help as well.
IMPORTANT: Tighten the Head-Locking
Screw until it firmly holds the Head
Assembly in place.
w WARNING
Cut and Crush Hazard.
Do not operate the Wheatgrass Juicer
without the Head Assembly firmly secured into place.
6
CAUTION:
Head
Make sure Screen
is properly seated
in the slot before
operation or unit
damage will occur.
Head
Auger
Auger Splines
Bearing
Auger
FIGURE 3
Rubber
Gasket
Aligning
Pin Inside
Receptacle
Head-
Locking
Screw
FIGURE 1
Slot
Screen
FIGURE 2
Head-
Waste
Valve
Waste
Cap
Valve
Washer
FIGURE 4
Cutout
in Head
Stomper