System Information - Onkyo BD-SP353 Mode D'emploi

• [HDMI Audio]
Select the output mode of HDMI Digital Out
jack, options include Bitstream, PCM,
Reencode and Off.
{Bitstream} – Output HDMI digital signal
without any processing.
{PCM} – Select this to output HDMI audio
signals converted to PCM audio signals.
{Reencode} – When a BD containing
secondary audio and interactive audio is
played, the two audio signals are mixed and
converted to Dolby Digital audio or DTS audio
for output.
{Off} – Select this function when HDMI audio
signals are not used.
• [Max Sampling Frequency]
Select the digital audio signal sampling
frequency.
{48KHz}, {96KHz}, {192KHz} – Outputs audio
signals that are limited to a sampling
frequency below the set sampling frequency
from the Digital Out jack. Select according to
the performance of the connected device.
Note:
• When playing back a sampling frequency
file or a disk having a lower than or equal
setting compared to the present setting,
you can output it at the unchanged
sampling frequency.
• Sources with sampling frequencies of over
192 kHz cannot be played.
• When playing copyright-protected discs or
files, the signals are output with the
sampling frequency limited to 48 kHz or
below, regardless of this setting.
• [DRC]
{Off} – Select this to output audio signals
without using the DRC function.
{On} – Select this to adjust the range between
the loudest and softest sounds (dynamic
range) for playback at average volume. Use
this when it is hard to hear dialog or when
watching movies at midnight.
{Auto} – Select to switch the DRC setting On/
Off automatically according to the input audio
signal from the disc. This only affects Dolby
TrueHD signals.
34
Note:
• This affects such audio signals as Dolby
Digital, Dolby TrueHD, and Dolby Digital
Plus.
• DRC affects audio signals output from the
following audio output terminals:
– Analog audio signals output from the
ANALOG AUDIO OUT terminals
– Linear PCM audio signals output from
the DIGITAL AUDIO OUT (OPTICAL) or
HDMI OUT terminals
• Depending on the disc, the effect may be
weak.
• The effect may differ depending on the
speakers, the AV amplifier settings, etc.
• [Downmix]
{Stereo}-Surround audio signals converted to
linear PCM audio signals are converted into
2-channel (stereo) signals for output.
{Lt/Rt}-Surround audio signals converted to
linear PCM audio signals are converted into
2-channel signals compatible with Dolby
Surround for output (when the connected AV
receiver or amplifier, etc., is compatible with
Dolby Pro Logic, the AV receiver or amplifier
outputs the linear PCM audio signals as
surround audio signals).

System Information

1. Press HOME MENU.
[General Setting] menu is displayed.
2. Press ► to select [System
Information].
- The current software version and MAC
address display
- Press ◄ to return to the previous menu.
- Press HOME MENU to exit the menu.
System Information
Software Version: XXXXXXXXXXXX
MAC:XXXXXXXXXXXX
Use cursor key to move focus, use "Enter" key
to select
Exit
• When you want to display the license of the
software that you are using in the device,
select "License".
Home Menu
License