Controls And Their Functions - Yamaha YST-RSW300 Mode D'emploi

CONTROLS AND THEIR FUNCTIONS

1
1
POWER switch
Normally, set this switch to the ON position to use the
subwoofer. In this state, you can turn on the subwoofer
or turn the subwoofer into the standby mode by
pressing the STANDBY/ON switch.
2
OUTPUT (TO SPEAKERS) terminals
Can be used for connecting to the front speakers.
Signals from the INPUT1 terminals are sent to these
terminals.
(Refer to "CONNECTIONS" for details.)
3
INPUT1 (FROM AMPLIFIER) terminals
Used to connect the subwoofer with the speaker
terminals of the amplifier.
(Refer to "CONNECTIONS" for details.)
4
INPUT2 terminals
Used to input line level signals from the amplifier.
(Refer to "CONNECTIONS" for details.)
4
En
Subwoofer rear panel
OUTPUT INPUT AUTO PHASE
TO SPEAKERS 2 STANDBY
/MONO
OFF HIGH
NORM REV
LOW
INPUT 1
FROM AMPLIFIER
POWER
ON
OFF
(U.S.A. model)
Subwoofer front panel
2
OUTPUT
TO SPEAKERS
R L
R L
FROM AMPLIFIER
INPUT 1
3
SUBWOOFER SYSTEM YST-RSW300
STANDBY/ON HIGH CUT
40Hz 140Hz
7 8 9
5
AUTO STANDBY (OFF/LOW/HIGH) switch
This switch is originally set to the OFF position. By
setting this switch to the HIGH or LOW position, the
subwoofer's automatic power-switching function
operates as described on page 13. If you do not need
this function, leave this switch in the OFF position.
Note
Make sure to change the setting of this switch only when
the subwoofer is set in the standby mode by pressing the
STANDBY/ON switch.
6
PHASE (NORM/REV) switch
Normally, this switch is to be set to the REV (reverse)
position. However, according to your speaker systems
or the listening condition, there may be a case when
better sound quality is obtained by setting this switch
to the NORM (normal) position. Select the better
position by monitoring the sound.
INPUT AUTO PHASE
2 STANDBY
L
/MONO
OFF LOW HIGH
NORM REV
R
4 5 6
VOLUME
0 10
0