Controls And Their Functions - Yamaha YST-SW105 Mode D'emploi

CONTROLS AND THEIR FUNCTIONS

OUTPUT
TO SPEAKERS
+ –
+ –
FROM AMPLIFIER
~
Power indicator
Lights up in green while the subwoofer is turned on.
Ÿ
STANDBY/ON button
Press this button to turn on the power. (The power
indicator lights up in green.)
Press again to set the subwoofer in the standby mode.
(The power indicator does not light.)
* This button can be used only when the POWER (
switch is set in the ON position.
Standby mode
The subwoofer is still using a small amount of power
in this mode.
!
B.A.S.S. (Bass Action Selector System) button
When this button is pressed in to the MUSIC position,
the bass sound in audio software is well reproduced.
By pressing the button again so that it pops out at the
MOVIE position, the bass sound in video software is
well reproduced.
MOVIE
8
E-
STANDBY/ B.A.S.S. HIGH CUT
ON
MOVIE
MUSIC
50Hz
INPUT
2
– +
/MONO
– +
INPUT
1
MUSIC
Front panel
VOLUME
150Hz 0 10
AUTO
STANDBY
OFF HIGH
LOW
Rear panel
⁄
HIGH CUT control
Adjusts the high frequency cut off point.
Frequencies higher than the frequency selected by this
control are all cut off (and no output).
* One graduation of this control represents 10 Hz.
›
)
@
VOLUME control
Adjusts the volume level. Turn the control clockwise to
increase the volume, and counterclockwise to
decrease the volume.
SUPERWOOFER SYSTEM YST-SW105
STANDBY/ B.A.S.S. HIGH CUT VOLUME
ON MOVIE
MUSIC
50Hz 150Hz 0 10
OUTPUT INPUT AUTO
2 STANDBY
TO SPEAKERS
+ – – +
/MONO
+ – – +
OFF HIGH
LOW
FROM AMPLIFIER
INPUT
1
POWER
ON
OFF
VOLTAGE
SELECTOR
HIGH CUT
50Hz 150Hz
POWER
ON
OFF
VOLTAGE
SELECTOR