Etherma LAVA BATH 2.0 Instructions D'installation Et D'utilisation page 10

W A L L M O U N T I N G
INSTALLING THE DESIGN INFRARED HEATING:
Please inspect the power supply cord to the heater and the
surface before installation. These must not show any signs of
damage.
Fasten hexagon bolts loosely on the rear side of the device.
1. Select a position for the mounting brackets according to the
illustrations on page 11, depending on the product type.
2. Drill the holes according to the hole clearances specifi ed on
page 11 or the drill template supplied.
3. Screw on the mounting brackets using suitable dowels and
screws.
4. Insert the LAVA ® BATH infrared heating on the mounting
brackets and tighten the screws.
NOTE
Follow the installation instructions for the towel holder for the
correct mounting on the device.
1
!!!
3
10
8 x
ATTENTION: Screws and dowels are not included
in the scope of delivery and must correspond to the
construction material of the wall.
ATTENTION:
and use the prescribed mounting holes.
ATTENTION: The LAVA
be mounted directly beneath a wall socket.
WARNING
To avoid danger to very young children, it is recommended that
this device be installed so that the lowest heated bar is at least
600 mm above the fl oor.
2
+
+
+
+
+
+
+
+
4
Observe the minimum clearances
infrared heating must not
®
8 x