Etherma LAVA STEEL 2.0 Instructions D'installation Et D'utilisation page 12

W A L L M O U N T I N G
INSTALLING THE DESIGN INFRARED HEATING:
Please inspect the power supply cord to the heater and the
surface before installation. These must not show any signs of
damage.
Fasten hexagon bolts loosely on the rear side of the device.
1. Select a position for the mounting brackets according to the
illustrations on page 13, depending on the product type.
2. Drill the holes according to the hole clearances specified on
page 13 or the drill template supplied.
3. Screw on the mounting brackets using suitable dowels and
screws.
4. Insert the LAVA infrared heating on the mounting brackets
®
and tighten the screws.
1
!!!
3
12
8 x
ATTENTION: Screws and dowels are not included
in the scope of delivery and must correspond to the
construction material of the wall.
ATTENTION:
Observe the minimum clearances
and use the prescribed mounting holes.
ATTENTION:
The LAVA
be mounted directly beneath a wall socket.
2
+
+
+
+
+
+
+
+ 8 x
4
infrared heating must not
®