Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
F. Attaching Top Cover Support Brackets
350 Model Only
3
Installing Foam Tape
2
OM-254 497 Page 18
3
1
2
1
350S Model Shown
250M Model Support
Brackets Shown
4
.
See Section 4-3B for installa-
tion hardware torque values.
1
Long Support Bracket
2
Short Support Bracket
3
Button-Head Screw
(350S Model Only) - Use eight 1/4
in. screws and nuts to attach two
short support brackets to each long
support bracket as shown.
Use two button-head 1/4 x 3/4 in.
screws for 250M models, or six for
350S model, two regular head 1/4 x
3/4 in. screws for 250M or 350S
model, and four nuts for 250M mod-
el or eight nuts for 350S model to
attach long and short support
brackets between perimeter ends
and extractor sides.
4
Foam Tape
Measure and cut proper length of
foam tape to fit across the top of the
long and short support brackets.
Peel off backing from tape and ap-
ply tape to support brackets.
Install long and short support
mounting brackets beneath
perimeter bracket, and also
beneath extractor.
3
300 964-3 / Ref. 300 963-2
Publicité
Table des Matières
