Section 4 − Assembly; Selecting A Location - Miller Filtair 250M Mode D'emploi

4-1. Selecting A Location

250M Model Shown
Front View
Bottom View
Perimeter Bracket
With Miller Label
! Only qualified persons should in-
stall, operate, maintain, and repair
this unit.
! Installation must meet all National,
State, and Local Codes − have only
qualified persons make this installa-
tion.
! Do not move or operate unit where it
could tip.
! Do not use this equipment to sup-
port personnel, large tools, or other
material.
! Be sure the floor or other structural
support will support the weight of
the equipment.
OM-254 497 Page 14
SECTION 4 − ASSEMBLY
1
Perimeter Bracket
With Miller Label
300 963-7
! Do not use equipment to support
site-installed ducts, interconnecting
piping, or electrical services. All
ducts, piping, or electrical services
supplied by others must be ad-
equately supported.
! Use only mounting hardware spe-
cifically designed for the structure
or material supporting the equip-
ment. Follow the recommendations
and installation guidelines provided
by the manufacturer of the mounting
hardware (if applicable).
350S Model Shown
Front View
Bottom View
Perimeter Bracket
With Miller Label
Moving The Equipment
1 Lifting Eye
Use lifting eyes and hoist to move the as-
sembled unit. See Section 4-3I for addition-
al lifting information.
Clearance
Maintain adequate clearance from heat
sources and avoid interference with utilities.
Ductwork
Select a location that ensures straight inlet
and outlet ducts and minimizes directional
changes in ductwork.
1
Perimeter Bracket
With Miller Label
300 964-7