Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
D. Assembling Extractor Housing
E. Attaching Extractor Housing And Left Side Perimeter Bracket
3
5
2
1
5
Install squaring
bracket beneath
perimeter bracket.
1
6
4
3
1
4
4
2
250M Model Shown
.
See Section 4-3B for installa-
tion hardware torque values.
1
Extractor Side Bracket
2
Extractor Top Bracket
3
Angle Flange Adapter Duct
4
Extractor Tray
Use five 1/4 x 3/4 in. screws and
nuts to attach extractor left side
bracket to right side bracket.
Use eight 5/16 x 3/4 in. screws to
attach extractor side brackets to
extractor tray.
Use six 3/8 x 1 in. Screws, washers
and nuts to attach angle flange
adapter duct to extractor top
bracket.
Use eight 1/4 x 3/4 in. screws and
nuts to attach extractor top bracket
to extractor side brackets.
250M Model Shown
300 963-5
.
See Section 4-3B for installa-
tion hardware torque values.
1
Extractor Housing
2
Right Side Perimeter Bracket
Use eight 5/16 x 3/4 in. screws and
nuts to attach extractor housing to
right side perimeter bracket.
3
Left Side Perimeter Bracket
4
End Perimeter Bracket
5
Corner
Use eight 5/16 x 3/4 in. screws and
nuts to attach extractor housing to
left side perimeter bracket.
Use ten 1/4 x 3/4 in. screws and
nuts to attach two corners to end
perimeter brackets.
6
Squaring Bracket
.
Before
installing
squaring
bracket, be sure perimeter is
square by measuring the dis-
tance between diagonally op-
posite corners. The perimeter
is square if the two measured
distances are equal.
Use eight 1/4 x 3/4 in. button-head
low-profile screws and nuts to
attach a squaring bracket at each
corner of the perimeter assembly.
300 963-4
OM-254 497 Page 17
Publicité
Table des Matières
