Panasonic WV-CW484 Série Mode D'emploi page 18

7. Secure the camera unit to the bracket with
the camera lock screw.
(The illustration describes an example using
a junction box.)
8. Adjust the camera. (Refer to p. 21.)
9. Attach the enclosure to the camera.
Firmly tighten the three tamper-proof
screws.
(Recommended tightening torque 0.78
N·m {0.58 lbf·ft})
Notes:
• Defocus may be caused by the reinstalled enclosure. When using a system controller,
adjust the back-focus on the setup menu after attaching the enclosure.
• When not using a system controller, back-focus adjustment is available by using the
[ABF2] button after attaching the enclosure.
q Press the [ABF2] button. The LED indicator will start blinking.
w While the LED indicator is blinking (for around 3 minutes), attach the enclosure to the
camera.
e When the LED indicator changes to steady light, back-focus will be adjusted automati-
cally.
r After the back-focus is adjusted, the LED indicator will go out.
• Do not aim the camera to objects continuously moving.
• If the LED indicator blinks again after changing to steady light, back-focus adjustment
may have failed. In this case, check the back-focus on the LCD monitor. To adjust the
back-focus again, perform Step q to e again.
18
Camera fixing screw