Panasonic WV-CW484 Série Mode D'emploi page 19

I Waterproof Process
• When routing cables sideway using Mounting Bracket or installing the camera under
eaves, apply waterproof process to the cable and relevant portions.
• The cables are not waterproofed. Provide water sealing for the tube ends and the portions
between cable cores as well as connecting portions.
• The use of vinyl tape or other tapes instead of the butyl tape may cause water absorption
from a gap and finally condensation and water leakage.
G Waterproof processing of cable connection
Surely use the provided butyl tape. (Do not use a sealing material on those parts.)
1. Connect and tape the power cables.
2. Bind the power cables together with the tape.
3. Tape the BNC-BNC joint of video output cable.
Power cable
Video output cable
Winding the provided butyl tape
Stretch the tape to about twice its original length as shown and wind the tape around the
cables. The tape will not harden if the tape is not stretched enough.
Stretch the tape to about twice.
Doubled length
19