Information Codes - Samsung DW60M9990AP Manuel D'utilisation

Troubleshooting

Information codes

If the dishwasher fails to operate, you may see an information code on the display. Check
the table below and try the suggestions.
Code
Leakage check
• Close the water supply valve. Go to your home's circuit breaker panel,
LC
Water supply check
• Check if the water supply valve is closed, if the water supply is
4C
Drain check
• Close the water supply valve. Check if the drain hose is clogged or
5C
High temperature heating check
• Functional check. With the dishwasher empty, add detergent, and then
HC
Pump operation check
3C • Functional check. Turn off the dishwasher and restart. If the issue
Zone wash function check
PC • Functional check. Turn the dishwasher off and try to start it again. If the
For any information codes not listed here, call for service at 1-800-SAMSUNG (726-7864).
40 English
DW9900M_DD68-00196B-03_EN.indd 40
and set the dishwasher's circuit breaker switch to off. Then, contact
the installer to repair. If the issue continues, contact a local Samsung
customer center.
suspended, or if the water inlet valve or line is frozen or clogged by
foreign particles. If the issue continues, contact a local Samsung customer
center.
folded. Check if the drain hole inside the pump is clogged. If the issue
continues, contact a local Samsung customer center.
run a cycle. If the issue continues, go to your home's circuit breaker
panel, and set the dishwasher's circuit breaker switch to off. Then,
contact a local Samsung customer center.
continues, contact a local Samsung customer center.
issue continues, contact a local Samsung customer center.
Action
7/9/2018 6:40:39 PM