Care And Maintenance - Energetics POWER RUN 4.8 Mode D'emploi

Cleaning
Routine cleaning of your treadmill will extend the product's life.
Warning : To prevent electrical shock, be sure the power to the treadmill is OFF and the power cord is
unplugged from the wall electrical outlet before attempting and cleaning or maintenance.
Important : Nover use abrasives or solvents to clean the treadmill. To prevent damage to the computer,
keep liquids away and keep it out of direct sunlight.
After each workout : Wipe off the console and other treadmill surfaces with clean, water dampened soft
cloth to remove excess perspiration.
Weekly : Use of a treadmill mat is recommended for ease of cleaning. Dirt from your shoes contacts the belt
and eventually makes it to underneath the treadmill. Vacuum underneath treadmill once a week .
Deck Lubrication
The walking belt has been pre-lubricated at the factory. However , it is recommended that the warking board
be checked periodically for lubrication to ensure optimal treadmill performance. Usually your treadmill should
not have to be lubricated usually within the first year or 500 hours of use.
Every 30 days or 30 hours of operation lift the sides of the walking belt and feel the top surface of the
walking board as far as you can reach. If there are signs of silicone, no further lunrication is required. If it
feels dry to the touch, follow the instructions below. Please use a non-pertroleum based silicone.
To apply luburicant to the walking belt:
1. Position the walking belt so that the seam is located on top and in center of the walking board.
2. Insert the spray nozzle into the spray head of the luburicant can.
3. While lifting the side of the walking belt, position the spary nozzle between the walking belt and the
board approximately 6 cm from the front of the treadmill. Apply the silicone spary to the walking
board, moving from the front of treadmill to the rear. Repeat this on the other side of the belt. Spary
approximately 4 seconds on each side.
4. Allow the silicone to "set" for 1 minute before using the treadmill.
Please keep children and pets away from the silicone oil in case of eating

Care and Maintenance

The home exerciser should not be used or stored in a moist area because of possible corrosion.
-
Check at least every 4 weeks that all connecting elements are tightly fitted and in good condition.
-
In case of repair please ask your dealer for advice.
-
Replace defective components immediately and/or keep the equipment out of use until repair.
-
Only use original spare parts for repair.
-
After exercising, immediately wipe off the sweat; perspiration can ruin the appearance and proper
-
function of the Home Exerciser.
Use a damp cloth to clean the Home Exerciser. Never use abrasives or solvents to clean the Home
-
Exerciser. To prevent damage to the computer, keep liquids away and keep it out of direct sunlight.
Inspect and tighten all parts of the treadmill regularly. Replace any worn parts immediately.
-
5