Publicité
Produktgruppe 511
9 von 36
en
Parts required
Quantity
Mat. no.
1
07312050
1
07312111
Note
Service and repair work should only be carried out by a suitably qualified electrician (with specialist training, knowledge and experience,
and recent related work experience) in accordance with all appropriate local and national safety regulations.
Servicing, modification, testing and maintenance of electrical appliances should only be carried out in accordance with all appropriate
legal requirements, accident prevention regulations and valid standards.
All regulations of the appropriate utility supply companies and standards relating to safety (not limited to electrical safety) are to be
complied with.
Note
Service and repair work on gas machines should only be carried out by suitably qualified persons in accordance with all appropriate local
and national safety regulations. Ensure all special regulations applying to gas installations are also complied with.
Before any service work is commenced, the machine must be disconnected from the gas mains.
Danger!
Even with the machine switched off, mains voltage may be applied to some components.
Before any service work is commenced, the machine must be disconnected from the mains. Suitable measurements must be made to
ensure that this is the case.
A general visual check should always be carried out.
Incorrect conversion or service work could lead to a risk of fire or gas explosion.
Danger!
Risk of injury
Risk of electric shock. Before any service work is commenced, the machine must be disconnected from the mains.
Fitting can only be carried out with the washing machine or tumble dryer not installed. For deinstallation, see the appropriate
operating instructions.
Risk of crushing. Wear slip-proof working gloves and safety shoes.
Risk of crushing. Ensure that parts of the body, especially the hands and feet are not positioned under or between machines.
Risk of accident. Ensure that children or pets cannot access the work area while fitting work is being carried out.
Risk of injury, particularly to the back. When carrying out this installation work, it is necessary to lay the washing machine on its
side. For this the relation of the weight of the machine to the physical strength of the technician must be taken into account. If this
instruction is not followed, serious injury, especially back injury, could be the result. For machine weight details, see the appropriate
operating instructions.
Risk of injury. Do not stand, or allow anyone to stand, on the drawer.
Risk of tipping. Risk of injury due to incorrect assembly.
Due to the risk of tipping, the machine must always be bolted to the plinth.
With a single machine installation, secure the plinth to the floor with the floor fastening kit Mat. no. 01497252.
All four plinth feet must be bolted to the floor.
The plinth is not suitable for use with a washer-dryer stack.
12.11.2010
Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
Designation
Conversion kit FFK5005
These fitting instructions
M.-Nr. 07312111
Publicité
