Publicité
Produktgruppe 511
10 von 36
Note
Tools required:
Spirit level for plinth levelling
Open spanner, 8 mm, for M5 nut
Torx 20 screwdriver
If holes need to be drilled in the plinth: 6 mm drill bit for steel, 7 mm drill bit for steel
Note
The kit, Mat. no. 07312050, contains the following:
1 filter box guide
1 drain plate
1 connection box
1 filter box (drawer)
1 lock
1 filter (surface filter)
1 accessory pack for fluff filter box fastening with case, 6 cheese-head bolts M5 x 12, 6 stainless-steel nuts M5, 6 stainless steel
washers B5.3, 2 pipe bends 70 x 87 PP (90° bend for drain path), 1 key.
1 information accessory pack with these fitting instructions and commissioning card.
List of illustrations:
Fig. 1, plinth front view with dimensions for two 6 mm dia. holes
Fig. 2, plinth rear view with dimensions for four 7 mm dia holes
Fig. 3, assembly of connection box (Pos. 1), guide rails (Pos. 2), drain plate (Pos. 3) with stopper bracket (Pos. 4) and plinth
Fig. 4, assembly of surface filter (Pos. 4) and drawer (Pos. 5)
Fig. 5, plinth with fitted fluff filter box showing position of the two 90° bends from machine drain into connection box
Fig. 6, detail of installation plan for plinth with fluff filter box for connection to drain
Fig. 6, legend for detail of installation plan
Abbreviation
AV
AW
DN 70
EL
FFK
KW
UM
WW
Table 1: Legend for detail of installation plan
If applicable, close the gas mains stopcock.
Disconnect the machine from the electrical mains and, if applicable, from the gas mains. Measures must be taken to ensure utility
supplies cannot be switched on again in error.
A new plinth has two 6 mm dia. holes in the front on the cover plate as shown, Fig. 1, and the rear has two 7 mm dia. holes in the cover
plate and a 7 mm dia hole in each rear foot, see Fig. 2.
With an unprepared or older plinth, two holes each are to be made in the front, see Fig. 1, and the rear, see Fig. 2, of the cover plate
and, in addition, one hole is to be drilled in each rear foot.
Place the connection box, Fig. 3, Pos. 1, in position at the rear of the plinth.
Fit the drain plate, Fig. 3, Pos. 3, with guide rails, Fig. 3, Pos. 2, with 4 M5 cheese-head bolts (torque 3.8 Nm).
Slide the guide rails, Fig. 3, Pos. 2, with the fitted drain plate at the rear onto the connection box threaded bolts, ensuring that the
stopper bracket on the drain plate faces the front, see Fig. 3, Pos. 4.
12.11.2010
Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Explanation
Model with drain valve
Drain connection
Pipe (drain pipe) diameter (diameter nominal) 70 mm
Electrical connection
Fluff filter box
Cold water connection (soft water)
Miele plinth
Hot water connection (soft water)
Umbau- und Montageanweisung
M.-Nr. 07312111
Publicité
