Publicité
Produktgruppe 511
34 von 36
Note
Tools required:
Spirit/bubble level for stand levelling
Open wrench, 8mm, for M5 nut
Torx 20 screwdriver
If holes need to be drilled in the stand: 6mm drill bit for steel, 7mm drill bit for steel
Note
The kit, mat. no. 07312050, contains the following:
1 filter box guide
1 drain plate
1 connection box
1 filter box (drawer)
1 lock
1 filter (surface filter)
1 accessory pack for lint filter box fastening with case, 6 M5 x 12 cheese-head bolts, 6 M5 stainless-steel nuts, 6 B5.3 stainless-
steel washers, 2 pipe bends 70 x 87 PP (90° bend for drain path), 1 key.
1 information accessory pack with these instructions and startup card.
List of illustrations:
Fig. 1, stand front view with dimensions for two 6mm dia. holes
Fig. 2, stand rear view with dimensions for four 7mm dia holes
Fig. 3, assembly of connection box (Pos. 1), guide rails (Pos. 2), drain plate (Pos. 3) with stopper bracket (Pos. 4) and stand
Fig. 4, assembly of surface filter (Pos. 4) and drawer (Pos. 5)
Fig. 5, stand with installed lint filter box showing position of the two 90° bends from machine drain into connection box
Fig. 6, detail of installation plan for stand with lint filter box for connection to drain
Fig. 6, legend for detail of installation plan
Abbreviation
AV
AW
DN 70
EL
FFK
KW
UM
WW
Table 1: Legend for Detail of Installation Plan
If applicable, close the gas shutoff valve.
Disconnect the machine from the electrical supply and, if applicable, from the gas supply. Measures must be taken to ensure that
utility supplies cannot be switched on again in error.
A new stand has two 6mm holes in the front on the cover plate as shown in Fig. 1, and the rear has two 7mm holes in the cover plate and a
7mm hole in each rear foot; see Fig. 2.
With an unprepared or older stand, two holes each are to be made in the front (see Fig. 1) and the rear (see Fig. 2) of the cover plate
and, in addition, one hole is to be drilled in each rear foot.
Place the connection box (Fig. 3, Pos. 1) to the rear of the stand.
Install the drain plate (Fig. 3, Pos. 3) with guide rails (Fig. 3, Pos. 2) with 4 M5 cheese-head bolts (torque 3.8 Nm).
Slide the guide rails (Fig. 3, Pos. 2) with the installed drain plate at the rear on the connection box threaded bolts. The stopper
bracket on the drain plate faces the front; see Fig. 3, Pos. 4.
12.11.2010
Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Explanation
Model with drain valve
Drain connection
Pipe (drain pipe) diameter, 70mm (nominal)
Electrical connection
Lint filter box
Cold-water connection (soft water)
Miele stand
Hot-water connection (soft water)
Umbau- und Montageanweisung
M.-Nr. 07312111
Publicité
