Philips Sonicare FlexCare Platinum Mode D'emploi page 13

Masquer les pouces Voir aussi pour Sonicare FlexCare Platinum:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

, To deactivate Easy-start: Press and hold the
power on/off button for 2 seconds. You hear 1
beep to indicate that the Easy-start feature has
been deactivated.
Note: Each of the first 14 brushings must be at least
1 minute in length to properly move through the
Easy-start ramp-up cycle.
Note: Using the Easy-start feature beyond the initial
ramp-up period is not recommended and reduces
Sonicare's effectiveness in removing plaque.
Cord wrap on charger (select models)
If your model includes the charger cover and base,
the travel charger is pre-installed inside the cover.
1
To separate the charger cover from the
charger base, press the two gray snap bars on
the charger base and pull the white charger
cover upwards.
2
Wrap excess power cord around the gray
charger base as shown in the picture.
Be sure to wrap the cord on the inside of the
two snap levers. Guide the power cord through
the small groove in the rear of the charger base.
3
To reattach the charger cover, press it down
over the charger base until it snaps into place.
Tip: For extra convenience during travel,
you can remove the travel charger and use it without
the charger cover and charger base.
EngliSh
13

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Hx9172Hx9112/12Hx9182/34Hx9182/32Hx9112/13Hx9172/15

Table des Matières