Bissell CROSSWAVE 1713 Série Mode D'emploi page 11

Maintenance:
Brush Chamber
WARNING
To reduce the risk of fire, electric shock or injury, turn power OFF and disconnect plug from
electrical outlet before performing maintenance or troubleshooting.
1
Turn off and unplug
the machine from the
grounded outlet.
4
With warm water, rinse
your brush roll window
and brush roll.
TIP: Running your machine with a wet brush roll will help the brush roll dry faster.
7
Replace brush roll by inserting the brush
roll end into the right side of the foot.
Then lock the pull tab into place by
pressing downward.
Cleaning the Brush Roll and
2
Grasp brush roll window
at the front and pull
upward to remove.
5
If your brush roll chamber
is dirty, clean with a rag
or towel.
8
Replace the brush roll window by first
lining up the brush window tabs with the
edges of the foot. Then press the window
back into place until you hear a click.
3
Pull brush roll out by
grabbing the brush roll
tab and pulling upward.
6
Let your brush roll
and brush roll window
chamber dry before
reassembling.
www.BISSELL.com
11