Bissell CROSSWAVE 1713 Série Mode D'emploi page 9

Maintenance:
WARNING
To reduce the risk of fire, electric shock or injury, turn power OFF and disconnect plug from
electrical outlet before performing maintenance or troubleshooting.
1
To release dirty water
tank, press down on
recessed button on the
top of the dirty tank.
NOTE: Your dirty water tank is full when the dirty water reaches the MAX fill line
and/or the float shuts off the suction motor.
4
To empty, pour dirty water and debris out.
Rinse the inside of the dirty water tank.
6
Hand wash the vacuum filter and screen
with warm water and mild detergent.
Empty Dirty Water Tank
2
Grab the front handle while
pressing down on button
and pull dirty water tank
away from the unit.
5
Remove the filter from the dirty water
tank top by pulling it up.
7
Rinse the float located at the bottom
of the dirty water tank's top.
3
Grasp top of dirty water
tank in recessed areas on
each side of the filter and
pull upward to remove the
top of the tank.
www.BISSELL.com
9